Removal |
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front passenger seat assembly.
|
3. |
Disconnect the PODS-F ECU connector. |
4. |
Remove the PODS-F ECU.
|
1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
2. |
Remove the front passenger seat assembly.
|
3. |
Disconnect the PODS-F ECU connector. |
4. |
Remove the front seat cushion assembly.
|
Installation |
1. |
Install the PODS-F ECU on the Front seat track assembly. |
2. |
Connect the PODS-F ECU connector. |
3. |
Install the front passenger seat assembly.
|
4. |
Reconnect the battery negative cable. |
5. |
After installing the PODS-F, confirm proper system operation :
|
1. |
Install the PODS-F Mat equipped seat cushion assembly on the front seat assembly.
|
2. |
Connect the PODS-F mat connector. |
3. |
Install the front passenger seat assembly.
|
4. |
Reconnect the battery negative cable. |
5. |
After installing the PODS-F, confirm proper system operation :
|
PODS-F Zeroing procedure |
1. |
Ignition “OFF”, connect GDS. |
2. |
Ignition “ON” & Engine “OFF”, select Airbag system and “PODS-F Reset” mode. |
3. |
The GDS will show the two PODS-F Zeroing function steps.
|
4. |
Select product configuration.
|
5. |
The PODS-F initialization procedure will be performed.
|
Headlight (Headlamp) welcome function
When the headlight is in the ON or AUTO position and all doors (and trunk) are
closed and locked, if you press the door unlock button on the smart key, the headlights
(and/or parking light) will com ...
Winter driving
Severe weather conditions in the winter result in greater wear and other problems.
To minimize the risks of winter driving, you should follow these suggestions: ...
Temperature Control Actuator Repair procedures
Inspection
1.
Ignition "OFF"
2.
Disconnect the connector of temperature control actuator.
3.
Verify that the temperature control actuator operates to the
hot position when connecting 12 ...