Inspection |
1. |
Remove the front door quadrant delta cover.
|
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Mirror Heater Inspection
Puddle Lamp
ECM
Side Repeater Lamp
Folding Mirror
Memory Mirror Inspection |
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle.
This is called the GVWR (Gross V ...
Road warning
...
Repair procedures
Replacement
[Removal]
•
Put on gloves to protect your hands.
•
Use seat covers to avoid damaging any surfaces.
1.
Remove the front pillar trim.
(Refer to Inte ...