Inspection |
1. |
Ignition "ON" |
2. |
Manually operate the control switch and measure the voltage of blower motor. |
3. |
Select the control switch to raise voltage until high speed.
Specification
*AUTO COOLING: Auto speed (4.5V~B+)
*AUTO HEATING: Auto speed (4.5V~11.3V) |
4. |
If the measured voltage is not specification, substitute with a known-good power mosfet and check for proper operation. |
5. |
If the problem is corrected, replace the power mosfet. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower cover (A) and then disconnect the connector (B). |
3. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws. |
4. |
Installation is the reverse order of removal. |
Filter replacement
1. Open the glove box and remove the support strap (1).
2. With the glove box open, remove the stoppers by turning them counterclockwise
on both sides.
3. Remove the climate control air fil ...
Seat Belt Pretensioner (BPT) Description and Operation
Description
The Seat Belt Pretensioners (BPT) are installed inside Center
Pillar (LH & RH). When a vehicle crashes with a certain degree of
frontal impact, the pretensioner seat belt helps ...
Troubleshooting
Troubleshooting
SymptomSuspected areaRepairmentPressing power switch does not turn on systemAVN head unit receiver power source circuitR-2AVN monitorR-15Panel switch does not functionSteering pad ...