Inspection |
1. |
The DDM inputs can be checked using the GDS. |
2. |
To check the input value of door lock switch, select option "IPM". |
3. |
Select option "DDM (Driver Door Module)". |
4. |
Select option "Input/Output monitoring". |
5. |
To check the input value of door lock switch in force mode, select option "ACTUATION TEST". |
Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Disconnect the power window switch module connector (A) from the wiring harness. |
4. |
Remove the power window switch module (B) from the door trim after loosening the mounting screws. |
Installation |
1. |
Install the power window switch module. |
2. |
Install the door trim panel after reconnecting the relevant connectors
|
Reprogramming a single HomeLink® button
To program a device to HomeLink® using a HomeLink® button previously trained,
follow these steps:
1. Press and hold the desired HomeLink® button.DO NOT release the button.
2. The indicator light wi ...
Reservoir Tank Repair procedures
Removal and Installation
1.
Disconnect the over flow hose (A), and then remove the resorvior tank (B).
Tightening torque:
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
2.
Installation ...
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance. Keep receipts for all vehicle emission services to protect
your warranty. Where both mileage and ...