Inspection |
1. |
Remove the front door trim panel.
|
2. |
Disconnect the connector from the motor. |
3. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and terminal No. 4 to battery (-). And then check that the motor
operates smoothly when connecting the terminals below.
If the operation is abnormal, replace the motor.
[Safety Power Window] |
1. |
Remove the rear door trim panel.
|
2. |
Disconnect the 2P connector from the motor. |
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction. If
the operation is abnormal, replace the motor. |
ESC Control Module Repair procedures
Removal
1.
Turn the ignition switch OFF.
2.
Remove the air duct (B) and air cleaner assembly (A).
3.
Remove the connector and then arrange the wiring harness (A).
4.
Remove the brake f ...
Accelerator Position Sensor (APS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Specification: Refer t ...
Reservoir Tank Components and Components Location
Components
1. Reservoir tank2. Over flow hose
...