Inspection |
1. |
When checking the driver power window switch, select a vehicle type and "IPM" menu. |
2. |
Select "DDM (Driver Door Module)". |
3. |
Select option "Input/Output monitoring". |
4. |
To check the input value of power window switch in force mode, select option "ACTUATION TEST". |
1. |
When checking the assist power window switch, select a vehicle type and "IPM" menu. |
2. |
Select "ADM (Assist Door Module)". |
3. |
Select option "Input/Output monitoring". |
4. |
To check the input value of power window switch in force mode, select option "ACTUATION TEST". |
Removal |
Driver Power Window Switch |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Disconnect the power window switch module connector (A) from the wiring harness. |
4. |
Remove the power window switch module (B) from the door trim after loosening the mounting screws.
|
Passenger Power Window Switch |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Disconnect the connector from the power window switch module. |
4. |
Remove the power window switch module (A) from the door trim after loosening the mounting screws. |
5. |
Remove the power window switch after loosening screws. |
Rear Power Window Switch |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear door trim panel.
|
3. |
Disconnect the connector (A) from the power window switch module. |
4. |
Remove the power window switch module (B) from the door trim after loosening the mounting screws. |
5. |
Remove the power window switch (A) after loosening the fixing clip. |
Installation |
1. |
Install the power window switch module. |
2. |
Install the door trim panel after reconnecting the relevant connectors
|
All season tires
HYUNDAI specifies all season tires on some models to provide good performance
for use all year round, including snowy and icy road conditions. All season tires
are identified by ALL SEASON and/or M+ ...
General Information
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Check the battery for damage, state of charge, and clean and tight c ...
Head Unit
(1) Press to turn power
on/off.
(2) (EJECT)
Press to insert or eject disc. When press and held(3seconds) : energency eject.
(3)
Converts to Radio (FM, AM, XM) mode. Each time this key is pres ...