Removal and Installation |
1. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose") |
2. |
Remove the cooling fan assembly.
(Refer to Cooling System - "Cooling Fan") |
3. |
Disconnect the ATF cooler hoses.
|
4. |
Disconnect the over flow hose.
(Refer to Cooling System - "Reservoir Tank") |
5. |
Remove the radiator mounting brackets (A).
|
6. |
Separate the condenser from the radiator and then pull radiator (A) up and remove it from engine room. |
7. |
Installation is in the reverse order of removal. |
8. |
Fill the radiator with coolant and check for leaks.
|
Inspection |
1. |
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. |
2. |
Apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Check for a drop in pressure. |
4. |
If the pressure drops, replace the cap. |
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester. |
2. |
Apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Inspect for engine coolant leaks and a drop in pressure. |
4. |
Remove the tester and reinstall the radiator cap.
|
Condenser Components and Components Location
Component Location
...
Blower Unit Components and Components Location
Component Location
Components
1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...
Components and Components Location
Component Location
1. Panoramaroof2. Panoramaroof switch3. Panoramaroof motor & controller4. Roller blind motor & slave controller
...