Hyundai Azera: Rear Back Armrest Cup Holder Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Cup Holder Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the rear back armrest. (Refer to Rear Seat - "Rear Back Armrest")

2.	Using a screwdriver or remover, remove the rear seat back armrest inner cover (A).

3.	Disconnect the connector (A).

4.	Using a screwdriver or remover, remove the rear seat armrest remote controll (A).

5.	Disconnect the connectors (A).

6.	After loosening the mounting screws, then remove the rear back armrest cup holder (A).

7.

Installation is the reverse of removal.

•	Make sure the connectors are plugged in properly.

•	Replace any damage clips.

Rear Back Armrest Cup Holder Components and Components Location

Component Location 1. Rear back armrest cup holder ...

Front Seat Belt

...

See also:

Defogging logic
To reduce the probability of fogging up the inside of the windshield, the air intake or air conditioning are controlled automatically according to certain conditions such as or positio ...

Shift Cable Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly 3. Control cable assembly4. Manual control lever (T/M side) ...

Front Hub - Axle Repair procedures
Replacement 1. Loosen the wheel lug nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire(A) from front hub. Tightening torque: 88.2 ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com