See also:
High Mounted stop lamp Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Disconnect the connector (A) of high mounted stop lamp.
4.
R ...
Power Mosfet Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
1. Drain2. Dr ...
Instrument panel illumination
The instrument panel illumination intensity can be adjusted as follows:
Ignition switch in the ON position
Pushing the control switch up or down
The illumination intensity is shown on the ...