Hyundai Azera: Rear Console Cover Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Remove the console rear complete assembly. (Refer to Floor Console - " Floor Console Assembly")

2.	After loosening the mounting screws, then remove the rear console cover (A).

3.	Disconnect the connector (A).

4.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damage clips.

Rear Console Cover Components and Components Location

Component Location 1. Rear console cover ...

Console Armrest Components and Components Location

Component Location 1. Console armrest ...

See also:

Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. To reduce the po ...

Side Impact Sensor (SIS) Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are ins ...

Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold tire pressures recommended for your vehicle, the number of people that can be in your vehicle and vehicle capacity ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com