Replacement |
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
After loosening the mounting screws, then remove the rear door frame rear garnish (A). |
3. |
Loosen the rear door channel mounting bolts and nut. |
4. |
Remove the rear door window glass mounting hole plug (B).
|
5. |
Carefully adjust the rear door window glass (A) until you can
see the bolts, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
6. |
Installation is the reverse of removal.
|
Components and Components Location
Components
1. Rear window glass2. Rear window glass molding
...
Repair procedures
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
...
Blower Unit Components and Components Location
Component Location
Components
1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...