Inspection |
1. |
The rear glass defogger switch inputs can be checked using the GDS. |
2. |
To check the input value of rear glass defogger switch, select option "IPM". |
3. |
To consult the present input/output value of IPM, "Current
DATA". It provides information of IPM input/output conditions of rear
defogger relay. |
4. |
To check the input value of rear glass defogger switch in force mode, select option "Actuation Test". |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the center fascia panel.
|
3. |
Remove the heater control unit (A) after removing screws. |
Installation |
1. |
Install the heater control unit. |
2. |
Install the center fascia panel. |
Cup holder
WARNING - Hot liquids
Do not place uncovered cups of hot liquid in the cup holder while the vehicle
is in motion. If the hot liquid spills, you may burn yourself. Such a burn to the
driver could le ...
Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first
turn the steering wheel right and left to clear the area around your front wheels.
Then, shift back and forth between ...
Limitation of Active ECO operation:
If the following conditions occur while Active ECO is operating, the system operation
is limited even though there is no change in the ECO indicator.
When the coolant temperature is low: The syst ...