Replacement |
|
1. |
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
2. |
Disconnect the connectors (A), and mounting wireing clips (B). |
3. |
After loosening the mounting screws, then remove the rear back armrest board (A). |
4. |
After loosening the mounting bolts, then remove the rear back armrest (A). |
5. |
Push the lock pin (B), remove the headrest (A). |
6. |
After loosening the mounting screws, then remove the rear seat back webbing guide (A). |
7. |
Pull out the headrest guides (A) while pinching the end of the guides, and remove them. |
8. |
Remove the hog-ring clips (A). |
9. |
After removing the velcro tape (A) and hog-ring clips (B) on the rear of seat back and remove the rear seat back cover (C). |
10. |
Installation is the reverse of removal.
|
Using the Room Mirror Key
Selecting the room mirror key will allow you to make service required inquiries,
POI info searches, and emergency rescues by connecting to the Blue Link® Center.
Such features can be used only after ...
Engine Hanger Repair procedures
Removal and Installation
[Front engine hanger]
1.
Remove the front engine hanger (A)
Tightening torque:
44.1 ~ 53.6N.m (4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)
2.
Install in the reverse ord ...
Door locks
...