Hyundai Azera: Rear Seat Belt Retractor Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the rear package tray trim. (Refer to Interior Trim - "Rear Package Tray Trim")

2.

After loosening the rear seat belt retractor (B) mounting bolt, then remove the rear seat belt (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

[Center]

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

3.

Installation is the reverse of removal.

•	Replace any damaged clips.

Rear Seat Belt Retractor Components and Components Location

Component Location 1. Rear seat belt retractor2. Rear center seat belt retractor ...

Rear Seat Belt Buckle Components and Components Location

Component Location 1. Rear seat belt buckle [LH]2. Rear seat belt buckle [RH] ...

See also:

26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided in ...

Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs are be ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com