Fuse Inspection |
1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
2. |
Are the fuse capacities for each circuit correct? |
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the crash pad lower panel.
|
3. |
Disconnect the connectors (A) from the IPM (Intelligent intergrated Platform Module). |
4. |
Remove the IPM after loosening the mounting nuts (4EA). |
5. |
Disconnect the connectors from the back side of the IPM. |
Installation |
1. |
Install IPM (Intelligent intergrated Platform Module). |
2. |
Connect the IPM connector. |
3. |
Install the crash pad lower panel. |
Windows
(1) Driver’s door power window switch
(2) Front passenger’s door power window switch
(3) Rear door (left) power window switch
(4) Rear door (right) power window switch
(5) Window opening and c ...
Description and Operation
Description
Block Diagram
LDWS is composed of below units
NoItemFunctionPosition1LDWS UNIT
1.
Lane Departure Warning System (LDWS) : Detects drive lane in
front and engages warning function i ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons:
1. Press and hold the two outer HomeLink® buttons until the indicator light begins
to flash after 10 seconds.
2. ...