Adjustment |
• |
Check the glass run channel for damage or deterioration, and replace them if necessary. |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Remove the front door window glass mounting hole plug (B). |
3. |
Carefully move the front door window glass (A) until the glass mounting bolts are visible, then loosen them. |
4. |
Check that the glass moves smoothly. |
• |
Make sure the door latches securely without slamming it. If
necessary adjust the striker (A): The striker nuts are fixed. The
striker can be fine adjusted up or down, and in or out. |
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches
properly, tighten the screws and recheck. |
|
1. |
Check that the door and body edges are parallel. |
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A) :
|
4. |
Grease the pivot portions of the hinges indicated. |
5. |
Check for water leaks. |
Components and Components Location
Component Location
1. Front deicer relay2. Washer3. Button Start 3(IG2) 4. Wiper(High)5. Blower relay6. Power outlet7. Wiper(Low)8. Button Start 2(IG1)9. Stop lamp10. Start11. Cooling fan(Low)12. ...
Transmitter Specifications
Specification
ItemDescriptionPower source3VOperating temperature-20°C ~ +60°CRF ModulationFSKRF frequency433.92MHzBattery1EA (CR2032)
An inappropriately disposed battery ca ...
Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required.
This child seat or infant seat should be of appropriate size for the child and should
be installed in accordance ...