Inspection (With GDS) |
1. |
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch. |
2. |
If diagnosis is required on the multifunction switch, select model and "BCM - Multifunction switch". |
3. |
To consult the present input/output value of Multifunction switch, "Current DATA". |
Removal |
1. |
Remove the steering column upper and lower shrouds after removing 3 screws. |
2. |
Disconnect the lighting switch and wiper & washer switch connector (A). |
3. |
If necessary of removing the wiper & washer switch (A)
only, release the lock of wiper switch using tool without removing the
steering wheel and the clock spring.
|
4. |
Remove the steering wheel.
|
5. |
Remove the clock spring.
|
6. |
Remove the multifunction switch assembly (A) after loosening the mounting screws (2EA). |
Installation |
1. |
Install the multifunction switch. |
2. |
Install the clock spring and steering. |
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel.
|
Inside Rear View Mirror Repair procedures
Replacement
[ECM Mirror]
1.
Remove the ECM mirror cover (A).
2.
Disconnect the ECM mirror connector (B).
3.
Loosen the ECM mirror mounting screw (A).
4.
Push the ECM mirror base up to ...
Hood Latch Release Handle Repair procedures
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
...
Hazard Lamp Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the center console upper assembly (A) with hazard lamp switch.
Apply the protective tapes to the center ...