Inspection |
1. |
Turn the ignition key to the "ON" position. |
2. |
Cover the front sensor to stop functioning. |
3. |
Shine a light at the rear sensor. |
4. |
The ECM should be darkened as soon as the rear sensor detects the light.
|
5. |
When the reverse gear is engaged, the ECM should not be darkened. |
6. |
When heading lights to both the front and rear sensors, the ECM should not be darkened. |
Removal |
1. |
Remove the mirror wiring cover (A) and disconect mirror connector (B). |
2. |
Remove the mounting screw (A). |
3. |
Remove the mirror (A) pulling up in the arrow direction.
|
Installation |
1. |
Install the mirror making sure the mounting bracket not to be damaged. |
2. |
Install the mirror wiring cover after reconnecting the connector and tightening the screw.
|
Master Cylinder Components and Components Location
Components
1. Reservoir cap2. Reservoir3. Grommet4. Master cylinder
...
Brake Line Repair procedures
Removal
1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
...
Auto Light Sensor Repair procedures
Inspection
In the state of IGN1 ON, when multi function switch module
detects auto light switch on, tail lamp relay output and head lamp low
relay output are controlled according to auto light ...