Removal |
1. |
Remove the front bumper.
|
2. |
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A). |
1. |
Open the trunk and remove the rear garnish assembly.
(Refer to Lighting System - "Rear Combination Lamp") |
2. |
Disconnect the connector and loosen 2 screws. And remove the back view camera(A). |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel in the driver side.
|
3. |
Remove the crash pad switch assembly(A) by pushing both clips.
|
Installation |
1. |
Install the front view camera. |
2. |
Install the front bumper. |
1. |
Install the rear view camera. |
2. |
Install the rear garnish assembly. |
1. |
Connect the connector and install the side switch assembly. |
Description and Operation
Description
The 6-speed automatic transaxle consists of an overdrive
clutch (OD/C), a one-way clutch (OWC), a lower and reverse brake (LR/B),
an underdrive brake (UD/B), a 26 brake (26/B), and ...
Power Door Lock Actuators Repair procedures
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
3.
Disconnect the connector (7P) from t ...
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...