To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps:
1. Press and hold the desired HomeLink® button.DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink® button, proceed with "Programming" step 2.
Defroster
CAUTION - Conductors
To prevent damage to the conductors bonded to the inside surface of the rear
window, never use sharp instruments or window cleaners containing abrasives to clean
the window.
& ...
Components and Components Location
Components
1. Front pillar trim2. Center pillar upper trim3. Rear pillar trim4. Cowl side trim5. Center pillar lower trim6. Front door scuff trim7. Rear door scuff trim
...
SS-B Solenoid Valve(ON/OFF) Description and Operation
Description
SS-B solenoid valve is attached to the valve body and is an
on/off solenoid valve that is used to change gears. SS-B Solenoid
valve(ON/OFF) is installed at valve body. ...