Hyundai Azera: Roof Side Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
| Replacement |
[General Type]
|
| 1. |
Using a screwdriver or remover, remove the roof side molding (A).
|
| 2. |
Installation is the reverse of removal.
|
[Panoramaroof Type]
|
| 1. |
Using a screwdriver or remover, remove the roof molding (A).
|
| 2. |
Installation is the reverse of removal.
|
Fender Garnish Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
See also:
Fuel Pressure Regulator Repair procedures
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
2.
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
3.
Remove the cushi ...
Rear Seat Belt Buckle Components and Components Location
Component Location
1. Rear seat belt buckle [LH]2. Rear seat belt buckle [RH]
...
Yaw-rate and G Sensor Description and Operation
Description
When the vehicle is turning with respect to a vertical axis
the yaw rate sensor detects the yaw rate electroniclly by the vibration
change of plate fork inside the yaw rate sensor.
...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com