Replacement |
|
1. |
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly") |
2. |
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly") |
3. |
Remove the console rear complete & console front complete assembly.
(Refer to Floor Console - "Floor Console Assembly") |
4. |
Remove the front pillar trim.
(Refer to Interior Trim - "Front Pillar Trim") |
5. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim") |
6. |
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim") |
7. |
Remove the sunvisor and retainer.
(Refer to Roof Trim - "Sunvisor") |
8. |
Remove the assist handle.
(Refer to Roof Trim - "Assist Handle") |
9. |
Remove the overhead console lamp.
|
10. |
Remove the room lamp.
|
11. |
Remove the ECM mirror cover (A). |
12. |
Disconnect the ECM mirror connector (B). |
13. |
Remove the rain sensor cover (A). |
14. |
Disconnect the rain sensor connector (B). |
15. |
Disconnect the roof trim main connectors (A). |
16. |
Detach the clips, then remove the roof trim assembly (A). |
17. |
Remove the vanity lamp.
|
18. |
Remove the hands free mic.
|
19. |
Installation is the reverse of removal.
|
Front fog light
Fog lights are used to provide improved visibility and avoid accidents when visibility
is poor due to fog, rain or snow etc.
The fog lights will turn on when :
1. The headlight is turned on.
2 ...
SS-A Solenoid Valve(ON/OFF) Schematic Diagrams
Circuit Diagram
...
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...