Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the room lamp assembly (A) with (-) screwdriver. |
3. |
Remove the LED bulb (A). |
1. |
Remove the lens (A) with (-) screwdriver. |
2. |
Replace the bulb after disconnecting a connector. |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the lens (A) with pushing the fixing clip (B). |
3. |
Replace the bulb after disconnecting a connector. |
1. |
Remove the crash pad LH garnish assembly.
|
2. |
Remove the LH mood lamp (A) after disconnection a connector. |
1. |
Remove the crash pad RH garnish assembly.
|
2. |
Remove the RH mood lamp (A) after disconnection a connector. |
Installation |
1. |
Connect a connector. |
2. |
Install the lamp assembly. |
3. |
Install the lens. |
1. |
Install the vanity lamp. |
Tire and loading information label
The label located on the driver's door sill gives the original tire size, cold
tire pressures recommended for your vehicle, the number of people that can be in
your vehicle and vehicle capacity ...
Components and Components Location
Components Location
1. Automatic transaxle2. Valve body assembly3. Oil pump assembly
...
Injector Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the injector terminals 1 and 2.
4.
Check that the resistance is within t ...