The SRSCM shall monitor the status of the driver and front
passenger seat belt buckle. The SRSCM provides one pin each for the
driver and front passenger seat belt buckle status input. The seat belt
buckle circuit operates from internal boost voltage supplied by the
SRSCM, and uses chassis ground for the signal return. The buckle status
shall modify the SRSCM deployment. If the buckle status is unbuckled,
the corresponding pretensioner will not be deactivated.
Removal
Front Side Impact Sensor
1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the door scuff trim.
(Refer to Body - "Door sc ...
See also:
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce
the risk of unauthorized vehicle use.
Whenever the ENGINE START/STOP button is changed to the ON position, the immobil ...
Rear Door Module Components and Components Location
Component Location
1. Rear door module
...
Additional safety precautions
All occupants should sit upright, fully back in their seats with their seat
belts on and their feet on the floor.
Passengers should not move out of or change seats while the vehicle is moving.
...