Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the floor console upper cover.
|
3. |
Remove the seat heater switch connector (A) from the floor console upper cover. |
4. |
Remove the seat heater switch assembly after loosining the screws (4EA). |
5. |
Operate driver seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch |
6. |
Operate assist seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Open the rear seat armrest (A). |
3. |
Remove the rear seat armrest upper cover (A).
|
4. |
Remove the seat heater switch assembly and cover (A).
|
5. |
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws. |
6. |
Turn rear seat heater switch ON and check that continuity exists between the terminals. |
7. |
If there is no continuity, replace the seat heater switch. |
Description and Operation
Function Of Safety Power Window
When driver door power window auto-up switch is operated, safety function is activated.
1.
Safety function condition
When detect the force of 100N (using the 10N/ ...
Rear curtain (if equipped)
To fold the rear curtain, press the button. To unfold the rear curtain, press
the button again.
CAUTION
Do not pull or fold the rear curtain by hand. It could cause motor failure.
The rear ...
Dynamic Damper Components and Components Location
Components
1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circlip
...