Removal |
1. |
Remove the center console assembly.
|
2. |
Remove the duct (A). |
3. |
Remove the control cable (B). |
4. |
Remove the control cable assembly in the vehicle after removing the nuts (B) and the retainer (A).
|
5. |
Remove the nut (C). |
6. |
Remove the cable (B) from the bracket (A) at transaxle assembly side.
(Refer to Automatic Transaxle System - "Automatic Transaxle") |
7. |
Remove the control cable inside of cab.
|
Installation |
1. |
Installation is the reverse of removal.
|
Adjustment |
Adjusting method for T/M control cable |
1. |
Make sure vehicle does not roll before setting room side
shift lever and Automatic Transaxle(AT) side manual control lever to "N"
position. |
2. |
Connect room side shift lever and control cable. |
3. |
Push cable to "F" direction shown to eliminate FREE PLAY. |
4. |
Tighten adjusting nut (A).
|
5. |
After adjusting, check to be sure that this part operates as
designed at each range of Automatic Transaxle(AT) side corresponding to
each position of room lever. |
Schematic Diagrams
System Block Diagram
Component Parts And Function Outline
Component partFunctionVehicle-speed sensorConverts vehicle speed to pulse.ECMReceives signals from sensor and control switches.Cruise cont ...
Storage compartments
These compartments can be used to store small items required by the driver or
passengers.
CAUTION
To avoid possible theft, do not leave valuables in the storage compartments.
Always keep the s ...
Tire chains
Tire chains, if necessary, should be installed on the front wheels.
Be sure that the chains are installed in accordance with the manufacturer's instructions.
To minimize tire and chain wear, do ...