Hyundai Equus Manuals

Hyundai Azera: Smart key unit Repair procedures - Smart key System - Body Electrical System - Hyundai Azera 2011-2022 Service ManualHyundai Azera: Smart key unit Repair procedures

Removal
   
-
Take care not to scratch the crash pad and related parts
Smart key unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the accelerator pedal module.
3.
Disconnect the smart key unit conector, and then remove the bracket and smart key unit (A) after loosening the screw and nut.

Door Outside Handle
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector after removing the door trim.
3.
Loosen the mounting bolt, then remove the door handle cover (B) and door lock (A).

4.
Remove the outside handle (A) by sliding it rearward.

5.
Disconnect the door outside handle connector (A).

Trunk lid open switch
1.
Disconnect the negative(-) battery terminal.
2.
Remove the trunk door trim.
3.
Disconnect the trunk lid open switch connector (A).

4.
Remove the rear combination lamp assembly (A) after loosening the nuts (9EA).
   
Be careful not to damage the guide boss on the combination lamp assembly.

5.
Remove the out side handle assembly (A) after removing the mounting screws and license lamps.

Inspection
Smart Key Unit
-
Refer to Lighting System - "Inspection/Self Diagnosis"
Smart Key Switch
-
Refer to Lighting System - "Inspection/Switch Diagnosis"
Antenna
-
Refer to Lighting System - "Inspection/Antenna Actuation Diagnosis"
Door Outside Handle
1.
Disconnect the front door outside handle connector (A).

2.
Check for continuity between terminals No 3 and No 6.

Standard value (Switch ON) : 0 ~ 1?

No
Description
1
Door antenna (+)
2
Pocket lamp LED (+)
3
Door lock/unlock button switch
4
Door antenna (-)
5
Pocket lamp LED (-)
6
Door lock/unlock button switch ground

Trunk Lid Open Switch
1.
Check for continuity between the Trunk lid open switch terminals.

2.
If continuity is not specified, inspect the switch.

Installation
Smart Key Unit
1.
Install the smart key unit.
2.
Install the smart key unit mounting nuts and screw and connector.
3.
Install the glove accelerator pedal.
4.
Install the negative (-) battery terminal and check the smart key system.
Trunk Lid Open Switch
1.
Install the trunk lid open switch on the rear combination lamp assebly.
2.
Install the rear combination lamp assembly.
3.
Install the negative (-) battery terminal and check the smart key system.
Door Outside Handle
1.
Install the outside handle.
2.
Install the door trim.
3.
Install the negative (-) battery terminal and check the smart key system.
Smart key unit Schematic Diagrams
Circuit Diagram ...

Smart key antenna Specifications
Specification Antenna ItemsSpecificationRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-30∞C ~ 75∞C (-22∞F ~ 167∞F)Frequency134.2kHzNumbersInterior(3EA), Door(2EA), Bumper(1EA) ...

See also:

Brake discs, pads, calipers and rotors
Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage. ...

Rear Package Tray Trim Repair procedures
Replacement     Х Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. Х Take care not to bend or scratch the trim and pan ...

If engine stalls while driving
1. Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place. 2. Turn on your emergency flashers. 3. Try to start the engine again. If your vehicle will not ...

Categories

Hyundai Azera Manuals

© 2011-2022 Copyright www.hgmanual.com