The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turning direction and speed of the steering wheel.
The HECU uses the signals from the SAS when performing ESC-related calculations.
Components (Steering Angle Sensor, Torque Sensor, Failsafe
relay, etc.) of the EPS system are located inside the steering column
& EPS unit assembly and the steering column. EPS unit assembly must
not be disassemble to be inspected. They must be replaced. (Refer to
“ST (Steering system) Gr.”)
Inspection
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer the Body - "Crash pad lower panel")
3.
Remove the crash p ...
See also:
Airbag Module Disposal Description and Operation
Airbag Disposal
Special tool required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those
in a whole vehicle to be scrapped), the airbags or side airba ...
Engine oil
...
Searching Radio Frequencies
Using Seek
Press the key to play the previous/next
frequency.
Using TUNE
Turn the ,
keys to select the frequency.
FM : Increases/decreased by 200kHz
AM : Increases/decreased by 10kHz
...