Inspection |
1. |
TEST TCM GROUND CIRCUIT: Measure resistance between TCM and
chassis ground using the backside of TCM harness connector as TCM side
check point. If the problem is found, repair it.
|
2. |
TEST TCM CONNECTOR: Disconnect the TCM connector and visually
check the ground terminals on TCM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it. |
3. |
If problem is not found in Step 1 and 2, the TCM could be
faulty. If so, make sure there were no DTC's before swapping the TCM
with a new one, and then check the vehicle again. If DTC's were found,
examine this first before swapping TCM. |
4. |
RE-TEST THE ORIGINAL TCM: Install the original TCM (may be
broken) into a known-good vehicle and check the vehicle. If the problem
occurs again, replace the original TCM with a new one. If problem does
not occur, this is intermittent problem (Refer to “Intermittent
Problem Inspection Procedure” in Basic Inspection Procedure). |
Replacement |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the negative (-) battery cable. |
3. |
Disconnect the TCM connector (A). |
4. |
Remove the Transaxle Control Module(TCM) (C) after removing the mounting bolts (A) and nut (B).
|
Installation |
1. |
Installation is reverse of removal.
|
Movable Glass Repair procedures
Replacement
1.
Open the movable glass fully.
2.
Remove the folding cover (A).
3.
After loosening the mounting screws, then remove the movable glass (A).
•
Do not ...
Key operations
Used to start the engine.
Used to lock and unlock the doors.
Used to lock and unlock the glove box.
WARNING - Aftermarket keys
Use only HYUNDAI original parts for the ignition key in your v ...
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Ignition "OFF".
2.
Disconnect evaporator temperature sensor.
3.
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Spe ...