Hyundai Azera: Troubleshooting
| Troubleshooting |
| Problem Symptoms Table |
Before replacing or repairing air conditioning components,
first determine if the malfunction is due to the refrigerant charge, air
flow or compressor.
Use the table below to help you find the cause of the
problem. The numbers indicate the priority of the likely cause of the
problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
| Standard : |
| Symptom | Suspect Area |
| No blower operation | 1. Blower fuse |
| 2. Blower relay | |
| 3. Blower motor | |
| 4. Power mosfet | |
| 5. Blower speed control switch | |
| 6. Wire harness | |
| No air temperature control | 1. Engine coolant level |
| 2. Heater control assembly | |
| 3. Air temperature control actuator | |
| No compressor operation | 1. Refrigerant capacity |
| 2. A/C Fuse | |
| 3. Compressor | |
| 4. A/C pressure transducer | |
| 5. A/C switch | |
| 6. Evaporator temperature sensor | |
| 7. Wire harness | |
| No cold air coming out | 1. Refrigerant capacity |
| 2. Refrigerant pressure | |
| 3. Drive belt | |
| 4. Compressor | |
| 5. A/C pressure transducer | |
| 6. Evaporator temperature sensor | |
| 7. A/C switch | |
| 8. Heater control assembly | |
| 9. Wire harness | |
| Insufficient cooling | 1. Refrigerant capacity |
| 2. Drive belt | |
| 3. Compressor | |
| 4. Condenser | |
| 5. Expansion valve | |
| 6. Evaporator | |
| 7. Refrigerant lines | |
| 8. A/C pressure transducer | |
| 9. Heater control assembly | |
| No engine idle-up when A/C switch ON | 1. Engine ECM |
| 2. Wire harness | |
| No air inlet control | 1. Heater control assembly |
| 2. Intake actuator | |
| No mode control | 1. Heater control assembly |
| 2. Mode actuator | |
| No cooling fan operation | 1. Cooling fan fuse |
| 2. Fan motor | |
| 3. Engine ECM | |
| 4. Wire harness |
Special Service Tools
Special Service Tools
Tool (Number and name)IllustrationUse09977-29000Disc & hub assembly bolt removerRemoval and installation of limiter assembly.
...
See also:
Description and Operation
Description
The hydraulic system consists of oil, an oil filter, an oil
pump, and a valve body (valves and solenoid valves). The oil pump is
powered by the engine. ATF passes through the oil fi ...
TPMS Receiver Description and Operation
Description
1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-L ...
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle or battery, follow the jump starting procedures.
If in doubt, we strongly recommend ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com