Troubleshooting |
Symptom | Suspect Area | Remedy (Refer to page) |
Water leaks from sunroof | Deteriorated roof lid weatherstrip | Replace |
Excessive roof lid-to-body clearance and improperly fitted weatherstrip | Adjust | |
Wind noise around sunroof | Loose or deformed deflector, gaps in body work | Re-tighten adjust or replace |
Noise heard when opening. closing sunroof | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
Loose guide rails and lid | Re-tighten | |
Motor runs but sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
Incorrect engagement of motor pinion with drive cable | ||
Decrease in motor`s clutch slipping force | ||
Increased sunroof sliding resistance or interference of sunroof
with drive cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed is not an unusual noise | Incorrect engagement of motor pinion with drive cable | Check pinion installation and |
Re-tighten motor | ||
Worn out or damaged motor pinion bearing | Replace motor assembly | |
Worn out or deformed drive cable | Replace | |
Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
Damaged or faulty regulator arm or regulator | Correct or replace | |
Door does not open or close completely | Incorrect door installation | Adjust position |
Defective door check assembly | Correct or replace | |
Door hinge requires grease | Apply grease | |
Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
Incorrectly installed hood | Adjust | |
Incorrect hood bumper height | Adjust | |
Water leak through windshield end rear window | Defective seal | Fill with sealant |
Defective flange | Correct |
Hood Latch Release Handle Repair procedures
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
...
Description and Operation
Description
Emissions Control System consists of three major systems.
•
Crankcase Emission Control System prevents blow-by gas from
releasing into the atmosphere. This system recycles gas ba ...
Adding equipment to or modifying your air bag-equipped vehicle
If you modify your vehicle by changing your vehicle's frame, bumper system, front
end or side sheet metal or ride height, this may affect the operation of your vehicle's
air bag system. ...