Hyundai Azera: Trunk Lid Latch Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Disconnect the trunk lid latch connector (A).

3.

Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.

Tightening torque :

6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.

Installation is the reverse of removal.

•	Make sure the trunk lid locks/unlocks and opens/closes properly.

Trunk Lid Latch Components and Components Location

Component Location 1. Trunk lid latch ...

Trunk Lid Key Holder Components and Components Location

Component Location 1. Trunk lid key holder ...

See also:

Owner maintenance precautions
Improper or incomplete service may result in problems. This section gives instructions only for the maintenance items that are easy to perform. As explained earlier in this section, several procedur ...

GAW (Gross axle weight)
This is the total weight placed on each axle (front and rear) - including vehicle curb weight and all payload. ...

Steering Angle Sensor Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turnin ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com