Hyundai Equus Manuals

Hyundai Azera: Valve Body Repair procedures - Hydraulic System - Automatic Transaxle System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Valve Body Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Automatic Transaxle System / Hydraulic System / Valve Body Repair procedures

Removal
1.
Remove the battery and the battery tray.
2.
Remove the under cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
4.
Remove the valve body cover (B) and eyebolt (A).
Tightening torque:
(A) 4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
(B) 13.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)
   
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

5.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the valve body assembly (A).
Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Installation is the reverse of removal.
   
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
   
•
Check fluid level after fill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
•
Replace the gasket (A) before reinstalling valve body cover.

Valve Body Components and Components Location
Components Location 1. PCV adjust screw2. Solenoid valve3. Oil temperature sensor4. Accumulator5. Low & reverse brake(LR/B) pressure flow hole6. Under drive brake (UD/B) pressure flow hole ...

Clutch & Brake
...

See also:

Basic Mode Screen
  (1) Mode Displays currently operating mode. (2) Operation State From Repeat / Shuffle / Scan, displays the currently operating function. (3) Track Info Displays information about the cu ...

Camshaft Position Sensor (CMPS) Specifications
Specification ItemSpecificationOutput Voltage (V)High: 5.0VLow: 0.7VAir Gap (mm)0.5 ~ 1.5 ...

Radiator Hose Components and Components Location
Components 1. Radiator upper hose2. Radiator lower hose3. Hose clip4. Clamp ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com