• |
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
• |
Put on gloves to protect your hands. |
• |
Take care not to scratch the body surface. |
|
1. |
Using a screwdriver or remover, remove the front waist line molding (A). |
2. |
Using a screwdriver or remover, remove the rear waist line molding (B). |
3. |
Installation is the reverse of removal.
• |
Replace any damaged clips. |
|
|
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
See also:
Components and Components Location
Component Location
1. Fuel filler door open switch2. Fuel filler door release actuator
...
Output Speed Sensor Specifications
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.8~1.25) 0.032~0.049Output voltageHigh1.18~1.68Low0.59~0.84
...
Components and Components Location
Components
1. Gear knob & Gear boots2. Console upper tray complete3. Center facia side garnish [RH]4. Center facia side garnish [LH]5. Console extension cover [RH]6. Console extension cover [ ...