Lug nut tightening sequence |
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) |
When using an impact gun, final tightening torque should be checked using a torque wrench. |
1. |
Jack up the vehicle. |
2. |
Measure the wheel Run-out by using a dial indicator as illustration below.
|
3. |
If measured value exceeds the standard value, replace the wheel. |
Basic Mode Screen
(1) Mode Display Displays currently operating mode.
(2) Channel Information Displays the category, channel number, channel
name, artist and song title.
(3) Preset Displays currently playing pre ...
Center Pillar Trim Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Blower Unit Components and Components Location
Component Location
Components
1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...