Inspection |
1. |
The windshield wiper / washer switch inputs can be checked using the GDS. |
2. |
To check the input value of windshield wiper/washer switch, select option "MFSW". |
3. |
To consult the present input/output value of IPM, "Current
DATA". It provides information of IPM input/output conditions of
windshield wiper / washer switch. |
Removal |
1. |
Remove the steering column upper and lower shrouds after removing 3 screws.
|
2. |
Remove the multifunction switch connector (A). |
3. |
If necessary of removing the wiper & washer switch (A)
only, release the lock of wiper switch using tool without removing the
steering wheel and the clock spring. |
4. |
Remove the steering wheel.
|
5. |
Remove the clock spring.
|
6. |
Loosen screws (2EA) and remove the multifunction switch assembly (A). |
Installation |
1. |
Install the multifunction switch. |
2. |
Install the clock spring.
|
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel. |
5. |
Install the driver airbag module.
|
Input Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...
Passenger Airbag (PAB) Module Description and Operation
Description
Passenger Airbag (PAB) module is located in the passenger
crash pad. This PAB contains 2 firing squibs of airbag and 1 firing
squib of active vent. Depending of crash speed or the t ...
Camshaft Position Sensor (CMPS) Schematic Diagrams
Circuit Diagram
...