Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, move the lever to the MIST position and release it with the lever in the OFF position. The wipers will operate continuously if the lever is held in this position.
OFF :
Wiper is not in operation.
INT :
Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob.
LO :
Normal wiper speed
HI :
Fast wiper speed
Aux, USB and iPod® port
If your vehicle has an aux, USB (universal serial bus) port or iPod® port, you
can use an aux port to connect audio devices, a USB port to plug in a USB and an
iPod® port to plug in an iPod®.
W ...
Front Driveshaft Components and Components Location
Component Location
1. Driveshaft(LH)2. Inner shaft bearing bracket assembly3. Driveshaft(RH)
Components
1. BJ Assembly2. Clip3. BJ Boot Band4. BJ Boot5. Dynamic Damper Band6. Dynamic Damp ...
Manifold Absolute Pressure Sensor (MAPS) Specifications
Specification
Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)20.0 (0.20, 2.90)0.7946.66 (0.47, 6.77)1.84101.32 (1.03, 14.7)4.0
...