Removal |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the floor console.
|
3. |
Disconnect the yaw rate & lateral G sensor connector (A). |
4. |
Remove the mounting bolts (B).
|
5. |
Installation is the reverse of removal. |
Calling by Dialing a Number
Press the key
Select [Dial Number]
1) Dial Pad : Used to enter phone number
2) Call : If a number has been entered, calls the number If no number has been entered,
switches to call history scre ...
Front fog light
Fog lights are used to provide improved visibility and avoid accidents when visibility
is poor due to fog, rain or snow etc.
The fog lights will turn on when :
1. The headlight is turned on.
2 ...
Front Oil Seal Repair procedures
Removal
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).
Installation
1.
Using SST(09231-3C100), install t ...