Hyundai Equus Manuals

Hyundai Azera: Accelerator Position Sensor (APS) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Accelerator Position Sensor (APS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification�

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation bolt (B) and nuts (C), and the remove the accelerator pedal medule.

Installation
1.
Installation is reverse of removal.

Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Accelerator pedal module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)

Accelerator Position Sensor (APS) Schematic Diagrams
Circuit Diagram ...

Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge con ...

See also:

Driver Airbag (DAB) Module and Clock Spring Components and Components Location
Components 1. Driver Airbag (DAB)2. Steering Wheel3. Clock Spring ...

Steering Column and Shaft Repair procedures
Replacement 1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the front wheels can face straight ahead. 3 ...

Intake Actuator Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grou ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com