Hyundai Equus Manuals

Hyundai Azera: Crash Pad Lower Panel Repair procedures - Crash Pad - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Crash Pad Lower Panel Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the crash pad side cover (A).

2.
Using a screwdriver or remover, remove the fuse box cover (A).

3.
After loosening the mounting screws, then remove the crash pad lower panel (A).

4.
Disconnect the diagnosis connector (A) and connector (B).

5.
Installation is the reverse of removal.
   
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.
Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and Components Location
Component Location 1. Glove box housing ...

See also:

Seat Belt Buckle Switch (BS) Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to Body - "Front seat") 3. Loosen th ...

Washer fluid
...

Valve clearance
Inspect excessive valve noise and/or engine vibration and adjust if necessary. An authorized HYUNDAI dealer should perform the operation. ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com