Hyundai Equus Manuals

Hyundai Azera: Door Lamp Repair procedures - Lighting System - Body Electrical System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Door Lamp Repair procedures

Removal
Mood lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
3.
Remove the connector(A) and door LED mood lamp(B).
   
Be careful not to damage LED reflection cable.

4.
Remove the rear door trim panel.
5.
Remove the connector and door LED mood lamp(A).
   
Be careful not to damage LED reflection cable.

Door lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
3.
Remove the rear door trim panel.
4.
Replace the door lamp bulb with turning the socket counterclockwise.
[Front Door]

[Rear Door]

Installation
Mood Lamp
1.
Install the door mood lamp and connector.
2.
Install the door trim.
3.
Connect the negative (-) battery terminal.
Door Lamp
1.
Install the door lamp and connector.
2.
Install the door trim.
3.
Connect the negative (-) battery terminal.
Overhead Console Lamp Repair procedures
Inspection Overhead Console Lamp Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...

License Lamp Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the license lamp (A) with loosening a screw. Installation 1. Install the bulb. 2. Install the license lamp lens. ...

See also:

ETC (Electronic Throttle Control) System Specifications
Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V)TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60.41984.650.3 ...

Fuel Pressure Control Valve (FPCV) Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on var ...

Hood Latch Release Handle Repair procedures
Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off the post. ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com