Hyundai Azera: License Lamp Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / License Lamp Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Lighting System / License Lamp Repair procedures
| Removal |
| 1. |
Disconnect the negative(-) battery terminal. |
| 2. |
Remove the license lamp (A) with loosening a screw.
|
| Installation |
| 1. |
Install the bulb. |
| 2. |
Install the license lamp lens. |
Door Lamp Repair procedures
Removal
Mood lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
3.
Remove the connector(A) and door LED mood l ...
Hazard Lamp Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the center console upper assembly (A) with hazard lamp switch.
Apply the protective tapes to the center ...
See also:
Knock Sensor (KS) Description and Operation
Description
Knocking is a phenomenon characterized by undesirable
vibration and noise and can cause engine damage. The two Knock Sensor
(KS) are installed inside the V-valley of the cylinder bl ...
Microphone Repair procedures
Inspection
1.
Disconnect the negative(-) battery terminal.
2.
Remove the roof trim.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the handsfree mic (A) after disconnect the connector f ...
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the e ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com