Hyundai Azera: Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures
| Removal |
| 1. |
Lift the vehicle. |
| 2. |
Disconnect the fuel filler hose (A). |
| 3. |
Disconnect the ventilation hose (B) from the fuel tank air filter.
|
| 4. |
Open the fuel filler door and then remove the filler-neck installation screw (A).
|
| 5. |
Remove the rear-LH wheel, tire, and the inner wheel house (A).
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).
|
| Installation |
| 1. |
Installation is reverse of removal.
|
Fuel Line Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
See also:
Oil Cooler Repair procedures
Removal and Installation
1.
Remove the radiator upper hose and lower hose.
(Refer to Engine Mechanical System - "Radiator Hose")
2.
Remove the cooling fan assembly.
(Refer to Engine Mechani ...
Idler Components and Components Location
Components
1. Idler
...
Troubleshooting
Troubleshooting
SymptomPossible causeRemedySpeedometer does not operateCluster fuse (10A) blownCheck for short and replace fuseSpeedometer faultyCheck speedometerCAN line faultyCheck the TCUWirin ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com