Hyundai Equus Manuals

Hyundai Azera: Accelerator Pedal Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Accelerator Pedal Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).

3.
Remove the installation nuts (B) and bolt (C), and then remove the accelerator pedal module.

Installation
1.
Installation is reverse of removal.

Accelerator pedal module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Filler-Neck Assembly Repair procedures
Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation hose (B) from the fuel tank air filter. 4. Open the fuel filler door and then remove ...

Delivery Pipe Repair procedures
Removal     In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure f ...

See also:

Electronic stability control (ESC)
The Electronic Stability Control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC appli ...

Front Wiper Motor Repair procedures
Removal 1. Loosen the windshield wiper arm nut (B) after removing a wiper cap (A). 2. Remove the windshield wiper arm and blade. 3. If necessary, release the wiper blade fixing clip by pul ...

Troubleshooting
Troubleshooting 1. The lamp switch inputs can be checked using the GDS. 2. To check the input value of lamp switch, select option "IPM". 3. To consult the present input/output value of IPM ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com