Hyundai Equus Manuals

Hyundai Azera: Front Pillar Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Front Pillar Trim Repair procedures

Replacement
   
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
•
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front pillar trim (A).

2.
Installation is the reverse of removal.
   
•
Replace any damaged clips.
Front Pillar Trim Components and Components Location
Component Location 1. Front pillar trim ...

Center Pillar Trim Components and Components Location
Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

See also:

Symbols used in this manual
Warnings, cautions and Notices WARNING A WARNING indicates a situation in which harm, serious bodily injury or death could result if the warning is ignored. CAUTION A CAUTION indicates a situatio ...

BJ Boot Components and Components Location
Components [LH] 1. BJ assembly2. Circlip3. BJ boot band4. BJ boot 5. Dynamic damper band6. Dynamic damper7. Shaft8. TJ boot band 9. TJ boot10. Spider assembly11. Snap ring12. TJ case 13. Circl ...

Oil Level Gauge & Pipe Repair procedures
Removal and Installation 1. Remove the oil level gauge (A). Tightening torque: 18.6 ~ 22.6N.m (1.9 ~ 2.3kgf.m, 13.7 ~ 16.6lb-ft)     When installing, apply engine oil to t ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com