Hyundai Azera: Front Rear Parking Assist System Switch Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel in the driver side.
|
| 3. |
Disconnect the connector and remove the side switch assembly by pushing both hooks.
|
| Installation |
| 1. |
Install the connector and crash pad side switch assembly. |
| 2. |
Install the negative (-) battery terminal. |
Parking Assist Sensor Repair proceduresChecking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available. However, use washer solvent
with antifreeze characteristics ...
Rear Combination Lamp Repair procedures
Rear Combination Lamp (Outside)
1.
Disconnect the negative (-) battery terminal.
2.
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A).
...
Check spark plugs and ignition system
Inspect your spark plugs as described in section 7 and replace them if necessary.
Also check all ignition wiring and components to be sure they are not cracked, worn
or damaged in any way. ...