Hyundai Azera: Parking Assist Sensor Repair procedures
| Removal |
| 1. |
Remove the front bumper.
|
| 2. |
Pull out the front sensor (A) from the sensor holder by opening the sensor holder out.
|
| 3. |
Disconnect the connector from the front sensor.
|
| 1. |
Remove the rear bumper.
|
| 2. |
Pull out the rear sensor (A) from the sensor holder by opening the sensor holder out.
|
| 3. |
Disconnect the connector from the rear sensor.
|
| Installation |
| 1. |
Install the parking assist sensor to the bumper. |
| 2. |
Connect the connector. |
| 3. |
Install the corresponding bumper. |
Parking Assist Sensor Schematic Diagrams
Front Rear Parking Assist System Switch Repair proceduresHeated Oxygen Sensor (HO2S) Troubleshooting
Wave Form
...
Engine Cover Repair procedures
Removal and Installation
1.
Remove the engine cover (A).
•
Lift up the lower end of engine cover, then left and right alternately.
•
When installing, confirm th ...
Fuel Pressure Control Valve (FPCV) Description and Operation
Description
Fuel Pressure Regulator Valve is installed on the high
pressure fuel pump and controls fuel flow flowing into the injectors in
accordance with the ECM signal calculated based on var ...