Hyundai Equus Manuals

Hyundai Azera: Trunk Lid Latch Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Trunk Lid Latch Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Repair procedures

Replacement
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the trunk lid latch connector (A).
3.
Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.
Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Installation is the reverse of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
Trunk Lid Latch Components and Components Location
Component Location 1. Trunk lid latch ...

Trunk Lid Key Holder Components and Components Location
Component Location 1. Trunk lid key holder ...

See also:

Heated Oxygen Sensor (HO2S) Schematic Diagrams
Circuit Diagram ...

Specifications
Specification Engine & T/MJoint typeMax. permissible angleInnerOuterOuterInnerRAMDA 3.0 MPI  A/TBJ#104PTJ#10045°21°RAMDA 3.3 GDI  A/TBJ#104PTJ#10045°21° Tightening Torque ...

Components and Components Location
Component Location 1. Slide motor2. Front height motor3. Rear height motor4. Lumbar support motor5. Recline motor6. Cushion extension motor7. Lumbar support switch ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com