Replacement |
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim") |
2. |
Remove the front door window glass mounting hole plug (B).
|
3. |
Carefully adjust the front door window glass (A) until you
can see the bolts, then loosen them. Separate the glass from the glass
run and carefully pull the glass out through the window slot.
|
4. |
Installation is the reverse of removal.
|
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle or battery, follow the jump starting procedures.
If in doubt, we strongly recommend ...
High Pressure Fuel Pump Repair procedures
Removal
In case of removing the high pressure fuel pump, high
pressure fuel pipe, delivery pipe, and injector, there may be injury
caused by leakage of the high pressure f ...