Replacement |
1. |
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass") |
2. |
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle") |
3. |
Loosen the rear door channel mounting bolts and nut. |
4. |
Loosen the mounting bolt (A). |
5. |
After loosening the rear door module mounting bolts, then remove the rear door module (A).
|
6. |
Remove the rear door channel (A). |
7. |
Disconnect the connectors and rear door module wiring harness (A). |
8. |
Installation is the reverse of removal.
|
Good braking practices
WARNING
Whenever leaving the vehicle or parking, always set the parking brake
as far as possible and fully engage the vehicle's transaxle into the P (Park)
position. Vehicles not fully eng ...
Front Oil Seal Repair procedures
Removal
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).
Installation
1.
Using SST(09231-3C100), install t ...
Power Out Side Mirror Switch Components and Components Location
Component
...